Omron SYSDRIVE 3G3FV - Page 94

3-14
Item Valid access levels Min.
Units
Output signal
levels for
multi-function
analog outputs
FunctionDisplayItem
Flux
Vec-
tor
Open
Vec-
tor
V/f
w/PG
V/f
Min.
Units
Output signal
levels for
multi-function
analog outputs
FunctionDisplay
U1-25 DI-16 Reference Monitors the reference value from a
3G3FV -PDI16H2 Digital Command Card.
The value will be displayed in binary or
BCD depending on parameter F3-01.
Can’t be output. --- A A A A
U1-26 V oltage Ref (Vq) Monitors the Inverter ’ s internal voltage
reference value for the motor
’s secon-
dary current control.
10 V : 200 (400) V AC
(0 to ± 10 V possible)
0.1 V X X A A
U1-27 V oltage Ref (Vd) Monitors the Inverter ’ s internal voltage
reference value for the motor
’ s excitation
current control.
10 V : 200 (400) V AC
(0 to ± 10 V possible)
0.1 V X X A A
U1-28 CPU ID Manufacturer’s CPU software ID number Can’t be output. 0.1 V A A A A
U1-32 ACR(q) Output Monitor’ s the current control output value
for the motor ’s secondary current.
10 V : 100% 0.1% X X A A
U1-33 ACR(d) Output Monitor’ s the current control output value
for the motor ’ s excitation current.
10 V : 100% 0.1% X X A A
U1-34 OPE Detected Displays the first constant number for
which an OPE error was detected.
Can’t be output. --- A A A A
U1-35 Zero Servo Pulse Multiplies the number of PG pulses by
four to display the movement width at the
zero servo stop point.
Can’t be output. 1 X X X A
U1-36 PID Input PID reference + PID reference bias – PID
feedback value
The max. frequency corresponds to
100%.
10 V :
Max. frequency
0.01
%
A A A A
U1-37 PID Output PID control output
The max. frequency corresponds to
100%.
10 V :
Max. frequency
0.01
%
A A A A
U1-38 PID Setpoint PID reference + PID reference bias
The max. frequency corresponds to
100%.
10 V :
Max. frequency
0.01
%
A A A A
Preparing for Operation Chapter 3