Remove a Front Indicator Panel
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause server components to fail. When you unpack the
replacement part, open the package on a grounded antistatic mat. Always use an antistatic wrist
strap for hardware replacements.
1.
Determine if a front indicator panel requires service.
See “Identify Faulted Components” on page 36.
2.
Take the necessary ESD precautions.
See “Prevent ESD Damage” on page 61.
3.
Shut down the server and switch off the appropriate PDU circuit breakers.
See “Removing Power From the Server or Domain” on page 69.
4.
Locate the indicator panel at the front of the server.
See “CMIOU Chassis Front Components” on page 20 or “Switch Chassis Front Components
(SPARC M7-16)” on page 23.
218 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
To Next Page
Loading...
Need help?
General