Oracle SPARC M8 User Manual (English)

To Next Page

To Previous Page

Configure POST

■

“Configure POST” on page 53

Configure POST

See “Log In to Oracle ILOM (Service)” on page 67.

Set the virtual keyswitch to the value that corresponds to the POST

configuration you want to run.

This example is for the SPARC M7-8 and sets the virtual keyswitch to normal, which

configures POST to run according to other parameter values.

-> set /HOST keyswitch_state=normal

Set 'keyswitch_state' to 'Normal'

Note - The value of keyswitch_state must be normal when individual POST parameters are

changed.

For possible values for the keyswitch_state parameter, see Oracle ILOM Administrator's

Guide for Configuration and Maintenance at http://www.oracle.com/goto/ilom/docs.

If the virtual keyswitch is set to normal, and you want to define level or verbosity,

set the respective parameters.

Syntax:

set /HOST/diag property=value.

For example:

-> set /HOST/diag default_level=max

-> set /HOST/diag default_verbosity=max

View the current values for settings.

For example:

-> show /HOST/diag

/HOST0/diag

Targets:

Properties:

default_level = max

default_verbosity = max

Detecting and Managing Faults 53

Oracle SPARC M8 Specifications

General

Oracle SPARC M8 User Manual