Panasonic DP-2330

305
DP-2330/3030
MAR 2005
Ver. 2.1
DP-2310/3010
(35) Execute Parameter Initialize by following the
steps below.
a) Press the "FUNCTION", "ORIGINAL SIZE
(LEDGER/A3)" and "3" keys simultaneously
in that order to enter the Service Mode.
b) Press the "9" and "START" keys to enter the
F9 Mode (Unit Maintenance)
c) Press "00 FAX Service Mode"
d) Press "06 RAM Initialize"
e) Press "01 Parameter Initialize" and the "Yes"
button
f) Press the "STOP" key
g) Press the "FUNCTION" and "C" (CLEAR)
keys simultaneously to exit the Service
Mode.
h) Turn the Power Switch on the Right side of
the machine to the OFF and back to the ON
position to enable the parameter settings.
(36) Verify the position of the stamp on the
document. If it is not within the desired location
at the bottom of the document, you can adjust its
position by following the steps below.
a) Press the "FUNCTION", "ORIGINAL SIZE
(LEDGER/A3)" and "3" keys simultaneously
in that order to enter the Service Mode.
b) Press the "6" and "START" keys to enter the
F6 Mode (Adjust Parameters)
c) Press "69 Stamp Position Adjust"
d) Press "INPUT" and enter a number
(-50 to 50).
Note:
A positive number moves the stamp
position closer to the trail edge of the
document, conversely, a negative number
moves it in the opposite direction.
To change the current sign to either +/-,
press the "RESET" key.
(Default setting = 0; 0.3 mm/step)
e) Press "OK" key twice.
f) Press the "FUNCTION" and "C" (CLEAR)
keys simultaneously to exit the Service
Mode.