Panasonic DP-2330

Local Firmware Update Tool (Parallel/USB Port)
1. General
The Local Firmware Update Tool (Parallel/USB) allows a Panasonic Fax/Copy machine to emulate a Flash
Memory Card Writer and create a Master Firmware Card, or to program the Firmware Code Memory of the Unit
directly. Using a PC, the firmware code is transferred to the Flash Memory Card or the Firmware Code Memory of
the Unit through the Parallel/USB Port on the Panasonic Fax/Copy machine. The installation and operation are
very similar to the Printer Interface.
1.1 Supporting OS
This application software operation has been confirmed under the following OS
•
•
•
Windows 98 / Me
Windows NT 4.0 (Parallel Port only)
Windows 2000 / XP
1.2 Supporting Panasonic Fax/Copier Models
A list of the compatible Panasonic Fax/Copy machines are shown below:
Parallel Port Models
Programming a Flash Memory Card
•
•
•
•
•
•
•
•
•
DP-130/135/150
DP-1510/1810/2010
DP-2000/2500/3000
DP-3510/4510/6010, DP-3520/4520/6020, DP-3530/4530/6030
UF-585/595/590/790/885/895/890/990, DX-2000
Direct Firmware Update
DP-1510/1810/2010
DP-3510/4510/6010, DP-3520/4520/6020, DP-3530/4530/6030
UF-E1
UF-490/525/UF-590/790
USB Port Models
Programming a Flash Memory Card
•
•
•
•
•
•
•
DP-180/190, UF-9000
DP-1520/1820
DP-2310/3010, DP-2330/3030
Direct Firmware Update
DP-180/190, UF-9000
DP-1520/1820
DP-2310 / 3010, DP-2330/3030
UF-7100/8000/8100
Note:
1. Depending on the destination, some Panasonic models may not be available.
2. Some UF-E1 models with the earlier versions of firmware will not support Parallel Firmware Update. Please
confirm whether your machine’s firmware version supports Parallel Firmware Update with your service provider.
Page 3