Physio Control LIFEPAK 15 - Page 291

LIFEPAK 15 Monitor/Defibrillator
Service Manual
Replacement Procedures
NIBP (A21)/CO2 (A23) Module Replacement
Section Menu Section Contents Procedures Back Index
293
8
2. For CO2 option:
NOTE: When replacing the CO2 module, use CO2 Module Repair
Kit (MIN 3305431-002) (p. 497).
a. Attach the CO2 module (3012140-006) to the mounting bracket
with four new screws (202253-760); torque to 4 in-lb.
b. Connect the OEM PCB/CO2 module cable (W26) to the A23 CO2 PCB
at J4.
c. Connect the CO2 adapter cable (W30) to the A23 CO2 PCB at J1.
 To install the A21 NIBP, A23 CO2, and SpO2 PCBs: (Continued) 12 steps, (Page 2 of 6)
CO2 option only
screws (4 places)
Figure 8.87—CO2 sub-assembly screw locations