User’s Manual of WGSW-20160HP/WGSW-24040HP series
• Wave Length(nm)
Display the wavelength of current SFP module, the wavelength value is get from
the SFP module. U
se this column to check if the wavelength values of two nodes
are the matched while the fiber connection is failed.
• Distance(m)
Display the supports distance of current SFP module, the distance value is get
from the SFP module.
Buttons
Auto-refresh : Check this box to enable an automatic refresh of the Page at regular intervals.
: Click to refresh the Page immediately.
4.4.5 Port Mirror
Configure port Mirroring on this Page. This function provide to monitoring network traffic that forwards a copy of each incoming
or outgoing packet from one port of a network Switch to another port where the packet can be studied. It enables the manager to
keep close track of switch performance and alter it if necessary.
• To debug network problems, selected traffic can be copied, or mirrored, to a mirror port where a frame analyzer can be
attached to analyze the frame flow.
• The Managed Switch can unobtrusively mirror traffic from any port to a monitor port. You can then attach a protocol
analyzer or RMON probe to this port to perform traffic analysis and verify connection integrity.
Figure 4-4-5: Port Mirror Application
To Next Page
Loading...
Need help?
General