Planet WGSW-20160HP - Qos DSCP Classification Mode; Qos DSCP Classification MAP

User’s Manual of WGSW-20160HP/WGSW-24040HP series
491
QoS DSCP Classification Mode
Description:
Set or show DSCP ingress classification mode.
If port DSCP classification is 'selected', DSCP will be classified based on QoS class and DP level only for DSCP value
with classification mode 'enabled'. DSCP may be translated DSCP if translation is enabled for the port.
Syntax:
QoS DSCP Classification Mode [<dscp_list>] [enable|disable]
Parameters:
<dscp_list>: DSCP (0-63) list or 'all'
enable : Enable DSCP ingress classification
disable : Disable DSCP ingress classification
(default: Show DSCP classification mode)
Default Setting:
disable
QoS DSCP Classification MAP
Description:
Set or show DSCP ingress classification table.
This table is used to map DSCP from QoS class and DP level. The DSCP which needs to be classified depends on port
DSCP classification and DSCP classification mode. Incoming frame DSCP may be translated beforeusing the value for
classification.
Syntax:
QoS DSCP Classification Map [<class_list>] [<dpl_list>] [<dscp>]
Parameters:
<class_list>: QoS class list or 'all', default: All QoS classes (0-7)
<dpl_list> : DP level list or 'all', default: All DP levels (0-1)
<dscp> : Mapped DSCP: 0-63, BE, CS1-CS7, EF or AF11-AF43
Default Setting:
disable