User’s Manual of WGSW-20160HP/WGSW-24040HP series
VCL Stasus
Description:
Show VCL MAC-based VLAN users configuration.
Syntax:
VCL Status [combined|static|nas|all]
Parameters:
combined|static|nas|all: VCL User
VCL Protocol-based VLAN Add Ethernet II
Description:
Add VCL protocol-based VLAN Ethernet-II protocol to group mapping.
Syntax:
VCL ProtoVlan Protocol Add Eth2 <ether_type>|arp|ip|ipx|at <group_id>
Parameters:
<ether_type>|arp|ip|ipx|at: Ether Type (0x0600 - 0xFFFF)
<group_id> : Protocol group ID
VCL Protocol-based VLAN Add SNAP
Description:
Add VCL protocol-based VLAN SNAP protocol to group mapping.
Syntax:
VCL
ProtoVlan Prot
ocol
Add S
nap <oui>|rf
c_1042|snap_802
1h <pid> <
group_id>
Parameters:
<oui>|rfc_1042|snap_8021h: OUI value (Hexadecimal 00-00-00 to FF-FF-FF).
<pid> : PID value (0x0-0xFFFF). If OUI is 00-00-00, valid range of PID is from 0x0600-0xFFFF.
<group_id> : Protocol group ID
To Next Page
Loading...
Need help?
General