User’s Manual of WGSW-20160HP/WGSW-24040HP series
6. Command Line Mode
The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command
modes are described below. Each of the command modes supports specific software commands.
Command Groups:
System System Settings and Reset Options
IP IP Configuration and Ping
Port Port Management
MAC MAC Address Table
VLAN Virtual LAN
PVLAN Private VLAN
Security Security Management
STP Spanning Tree Protocol
Aggr Link Aggregation
LACP Link Aggregation Control Protocol
LLDP Link Layer Discovery Protocol
LLDPMED Link Layer Discovery Protocol Media
PoE Power Over Ethernet
QoS Quality of Service
Mirror Port Mirroring
Config Load / Save of Configuration via TFTP
Firmware Download of Firmware via TFTP
UPnP Universal Plug and Play
MVR Multicast VLAN Registration
Voice VLAN Specific VLAN for Voice Traffic
Loop Protect Loop Protection
IPMC MLD / IGMP Snooping
VCL VLAN Control List
SMTP SMTP Control Configure
To Next Page
Loading...
Need help?
General