User’s Manual of WGSW-20160HP/WGSW-24040HP series
Security Switch Access Configuration
Description:
Show access management configuration.
Syntax:
Security Switch Access Configuration
Security Switch Access Mode
Description:
Set or show the access management mode.
Syntax:
Security Switch Access Mode [enable|disable]
Parameters:
enable : Enable access management
disable: Disable access management
(default: Show access management mode)
Default Setting:
disable
Security Switch Access Add
Description:
Add access management entry, default: Add all supported protocols.
Syntax:
Security
Switch Ac
cess Add <access_id>
<start_ip_addr> <end_ip_addr> [web] [snmp] [telnet]
Parameters:
<access_id> : entry index (1-16)
<start_ip_addr>: Start IP address (a.b.c.d)
<end_ip_addr> : End IP address (a.b.c.d)
web : Indicates that the host can access the switch from HTTP/HTTPS
snmp : Indicates that the host can access the switch from SNMP
telnet : Indicates that the host can access the switch from TELNET/SSH
To Next Page
Loading...
Need help?
General