Planet WGSW-20160HP - Qos Port Storm Multicast; Qos Port Storm Broadcast

User’s Manual of WGSW-20160HP/WGSW-24040HP series
493
QoS Port Storm Multicast
Description:
Set or show the port storm rate limiter for broadcast frames.
Syntax:
QoS Storm Multicast [enable|disable] [<packet_rate>]
Parameters:
<port_list>: Port list or 'all', default: All ports
enable : Enable storm policing of broadcast frames
disable : Disable storm policing of broadcast frames
<rate> : Rate in kbps or fps (100-13200000)
kbps : Unit is kilo bits per second
fps : Unit is frames per second
Default Setting:
disable
QoS Port Storm Broadcast
Description:
Set or show the broadcast storm rate limiter.
The limiter will only affect flooded frames, i.e. frames with a (VLAN ID, DMAC) pair not present in the MAC Address table.
Syntax:
QoS Storm Broadcast [enable|disable] [<packet_rate>]
Parameters:
enable : Enable broadcast storm control
disable : Disable broadcast storm control
<packet_rate>: Rate in fps (1, 2, 4, ..., 512, 1k, 2k, 4k, ..., 32768k)
Default Setting:
disable