Administrator’s Guide for the Polycom RealPresence Group Series Introducing the RealPresence Group Series
Polycom, Inc. 22
Use the USB port for any USB 2.0 device.
Brief status and diagnostic messages are displayed in the status display area of the RealPresence
Group 700 system. The LED on the front of all RealPresence Group systems provides the following
information.
Ref.
Number Description
1 LED indicator light
2 Power sensor
3 Status display area
4 USB 2.0 port
5 Restore button
If your RealPresence Group 700 systems operates with the Maximum Security Profile, the status
display area does not display the software version or IP address.
Indicator Light System Status
Off System is powered off.
Blinking blue light In a POST sequence, no errors are occurring and tests are successful. The
system continues to blink blue and initializes after the sequence is complete
if no severe errors occur.
Blinking amber light In a POST sequence, at least one test has resulted in a warning error. The
system continues to blink amber but initializes after the sequence is
complete if no severe errors occur.
Blinking red light In a POST sequence, at least one test has resulted in a severe error. The
system continues to blink red and will not start up.
Steady blue light System is initializing.
System is awake.
Blinking blue light System received an IR (infrared) signal.
System is receiving a call.
Steady amber light System is asleep.
Alternating blue and amber lights System is in software update mode.
System is in factory restore mode.
Fast blinking amber light System is shutting down.
Steady green light System is in a call.
To Next Page
Loading...
