© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 160
8 Fasten a replacement 1/4-20X1 screw and shim in one of the cam clamp screw holes, do not fully tighten
at this time.
9 Slide the flat belt loop into the cam clamp until the side of the flat belt is resting next to the clamp screw.
Push the pin into the flat belt loop; ensure the pin is centered within the cam clamp.
Flat Belt Installation - Upper Arm Cam
10 Lay the replacement flat belt on a flat surface with the flat belt segments facing up. Measure the distance
in from the end of the flat belt 10 inches, using a straight edge and permanent marker draw a line across
the flat belt at 10 inches. Repeat this process for the other end of the flat belt.
11 Place the inside flat belt on the cam so the length of the flat belt is draped towards the back of the AMT.
Make sure the smooth side of the flat belt contacts the cam and the segmented side is facing up.
FIGURE 142: OUTSIDE FLAT BELT ROUTING - CAM
To Next Page
Loading...
