© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 251
7 – Adjustment Procedure
In This Section
Measuring the Resistance of a Generator ........................................................
Inspecting and Adjusting the H-brake Belt Tension
Inspecting and Adjusting the Generator Belt Tension ......................................
Inspecting and Adjusting the Drive Input Belt Tension .....................................
Calibrating the Incline Motor .............................................................................
Drive Belt Gauge Instructions
Measuring the Resistance of a Generator
Caution: If an external power supply is connected to the AMT, disconnect the external power supply from
the AMT before continuing with this procedure.
Procedure
1 Remove the right side cover as per Procedure, Cover Replacement (on page 53).
2 Remove the positive battery wire from the lower PCA.
FIGURE 249: BATTERY
WARNING: Before continuing with this procedure, review the Warning and Caution statements listed
in the Warning and Caution Statements and General Safety Guidelines Section, Things You Should
Know.
To Next Page
Loading...
Need help?
General
