© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 262
14 Tighten the two 5/16-18 X 3 generator mounting bolts.
15 Select the QUICKSTART program and adjust the resistance key until resistance level 10 is displayed.
Pedal the AMT for approximately one minute and then recheck the belt tension.
16 Recheck the generator belt tension, readjust if out-of-spec.
FIGURE 258: GENERATOR
17 Replace the main covers as per procedure, Cover Replacement (on page 53).
To Next Page
Loading...
Need help?
General
