© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 87
Replacing a Stairarm
FIGURE 49: STAIRARM AND FRONT ARM
Stairarm Replacement Procedure
Rear Flat Belt Terminal Cover Removal
1 Remove the two #10-24 X 1.25 screws that secure the flat belt terminal covers to the flat belt terminal,
remove the outside terminal cover.
2 Rotate the top of the inside terminal cover down until it is below the stairarm pedal, pull to remove.
3 Repeat the process for the remaining rear flat belt terminal cover.
To Next Page
Loading...
