Precor AMT12 base - Crank Arm Alignment

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 183
drive input housing cavity, just below the crank arm to prevent rotation and torque the mounting bolt to
300 inch pounds or 25 foot pounds.
Note The position of the flat belt pulley on the crank arm and the flat belt pulley on the input pulley. When
the crank arm is replaced, the flat belt pulleys must be positioned so that they are 180 degrees opposing.
FIGURE 168: CRANK ARM ALIGNMENT
FIGURE 169: CRANK ARM BOLT REMOVAL/ INSTALLATION