© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 235
8 Using needle nosed pliers, pull the retaining clip off the lower gas mounting stud and remove shock.
Incline Motor Removal
9 Remove the hitch pin from the Incline motor mounting pin.
10 Remove the Incline motor mounting pin. If the Incline is jammed or has excessive pressure on the pin,
it may be necessary to drive the pin out of the Incline motor tube and Incline platform using a punch and
rubber mallet.
FIGURE 236: INCLINE MOTOR HITCH PIN AND MOUNTING PIN
To Next Page
Loading...
Need help?
General
