Section 18: BODY
PA1562
10
4.2 Rear wheelhousing
(Entire braking system)
4.3 Rear wheelhousing
5.0 Close off wheelhousing using masking paper. Prevent rust inhibitor from coming in contact with paint.
To close off wheelhousing, a polythene sheet may be
used.
6.0 Apply TECTYL 185 GW black rust inhibitor onto
wheelhousing mechanical parts.
A spray gun and pumping system are required to apply
the rust inhibitor. If the application is done inside a paint
room, select high speed ventilation. Minimum required
thickness is 10 mils wet or 5 mils dry.
7.0 Remove all masking material 30 minutes after
application.
ANNEX 1
1. Check and confirm that dew point and surface temperature are in accordance with to the following
criteria:
Surface temperature > 10°C
Surface temperature > or = to dew point + 3°C
NOTE
Use the following table to determine dew point.
2. Check and confirm that TECTYL temperature is between 10°C and 35°C.
To Next Page
Loading...
