Section 18: BODY
PA1562
29
• Check body panel flatness using a 2-foot
ruler (must be within 2mm).
• Check proper power window sliding inside
window frame.
• If applicable, remove excess of Sika
adhesive all around door frame using Sika
208.
• From the inside of the door, apply some
Sika 221 between door body panel and
frame and on welding spots as per figure.
• Apply some #680066 glue inside fiber glass
groove and fix power window wiper.
NOTE
Anti-friction side must be on glass side.
• From inside the door, apply some Sika 252
at the corners of window wiper.
• Apply some #680066 glue inside finishing
panel groove and fix power window wiper.
NOTE
Anti-friction side must be on glass side.
• Discard waste according to applicable
environmental regulations, use dangerous
waste containers.
Electrical Power Window
• Insert 2 seals in the window frame.
• Apply some #680066 glue at the intersection
of the 2 seals and also sparingly in order to
fix the seal to the window frame.
• Clean window using window cleaner.
To Next Page
Loading...
