Section 18: BODY
PA1562
63
Section D Sika Primer 215
1. Shake bottle to mix product
2. Apply a thin layer
3. Allow drying
Minimum time : 20 minutes Mandatory 215
After 2 hours : Remove dust using damp cloth (pure water)
If surface seems dusty, dust using damp cloth.
Before applying any other
product
If surface seems greasy or with finger marks, reactivate with Aktivator.
PREPARATION OF FIBERGLASS
1. Clean using anti-silicone (refer to Section A).
2. Apply Sika 205 (refer to Section B).
Section D Sika Primer 215
1. Apply
2. Allow drying
- For a smooth surface (aluminum, stainless, steel,
fiberglass (gelcoat side), etc.):
2 minutes Minimum
time
- For a porous surface (fiberglass (non gelcoat side),
etc.)
10 minutes
Mandatory
After 2 hours : Reactivate surface with Sika 205
Before applying any other
product
If surface seems dusty, greasy or with finger marks, start
operation again.
X3 VEHICLES FRONT STEPS GLUING
1. Use step nosing to measure and cut necessary length of white safety strip.
2. Use a screw to check depth of countersinking in step nosing. Screw top must not stick out beyond the
aluminum surface. Countersink if needed.
CHIX cloth
CHIX cloth
To Next Page
Loading...
