Section 23: ACCESSORIES
PA1562
22
CAUTION
Because they are made of plastic, firmly
tighten nozzle and bulkhead fittings by hand
only.
FIGURE 30: TUBING AND FITTINGS 23381
FIGURE 31: WASHER NOZZLES ADJUSTMENT 23382
9. WINDSHIELD WIPERS AND WASHERS
9.1 GENERAL DESCRIPTION
NOTE
When installing a wiper motor, arm or blade,
follow recommended procedures to prevent
misalignment, binding or malfunction. Check
the windshield washer liquid hoses, fittings
and connectors to be sure they are properly
connected and seal with no restriction to the
flow of washer liquid. Check that wiper arms
have the proper sweep position and the
washer nozzles are aimed so that spray is
within the proper wiper pattern.
The windshield wipers are controlled by one
electric wiper motor that is accessible for mainte-
nance after removing the appropriate access
panel beside the footwell (refer to figure 34).
Turn the multifunction lever forward to activate
windshield wipers (item 2, fig. 32). The first
position operates the wipers at low speed and
the second position operates the wipers at high
speed. Turning the lever backwards will operate
the wipers in the intermittent mode.
FIGURE 32: MULTIFUNCTION LEVER 23133
FIGURE 33: WINSHIELD WASHER RESERVOIR 23220
To Next Page
Loading...
