MULTIPLEX MODULES DISCONNECTION PROCEDURE PRIOR TO
WELDING
PROCEDURE NO: PR060034
REVISION 4
2007-05-31
Page 1 de 15
Material : N/A
Equipment(s) : Phillips-head screwdriver
Ratchet handle
3/8" socket
Electric tape
Long nose pliers
Reference schematics: N/A
Safety rules : - Wear safety goggles
- Set the battery master switch to the OFF position first
Recommendations: This procedure should be performed by qualified personnel only.
Effective
Revision 0 : Issued with multiplex
Revision 1 : Modified for Fire Protection System and also for VIP with multiplex
Revision 2 : Step 5 modified for introduction of VIP with multiplex -0436
Revision 3 : Step 1.15 added C397
Addition of SECTION 2 for X3 Coaches
Addition of SECTION 3 for XLII MTH
Revision 4 : Modified for introduction of CPC module for VIP,H3 Coach, X3 7-0942VIP
8-1037 H3
8-9282 X3
To Next Page
Loading...