PROCEDURE NO: PR060034
REVISION 4
Page 15 of 15
Location: Wiper Control Panel
Remove windshield wiper motor access panel
And disconnect I/O B modules
2.30
When all the previous steps are done, you can do
welding on the vehicle
ENSURE THAT THE WELDING GROUND
RETURN CLAMP IS WELL SECURED AND
MAKES A GOOD ELECTRICAL CONTACT
WITH A LARGE METALLIC AREA OF THE
CHASSIS LOCATED NEAR THE WELDING
POINT AS MUCH AS POSSIBLE
2.35
When welding is completed, reconnect all the
modules.
Make sure that the connectors locking tab are well
engaged!
BE CAREFUL TO MAKE THE PROPER
CONNECTIONS, IF NOT, SOME SYSTEMS
OR COMPONENTS MAY NOT BE USABLE
To Next Page
Loading...