Page No.7
Manual No. NDS8
Spicer Speciality Axle Division - Technical Publications
© Spicer Speciality Axle Division
OVERHAUL PROCEDURES
HUB END REASSEMBLY
1. Follow instructions contained in swivel
/ axle bed reassembly section, before
attempting to reassemble hub end.
2. Fit Unitised hub bearing guide sleeve
onto swivel stub .
(see chart at front of swivel section)
3. Lightly smear the axle stub bearing
journal with a thin layer of anti-fretting
assembly paste, white
i.e Optimol Paste White T (Castrol) or
equivalent.
4. Offer new unitised bearing onto swivel
stub.
To Next Page
Loading...
