3
main local global operation trouble-
menu search search shooting
Perform operating and leakage tests as described in Ser-
vice Checks section.
IMPORTANT! PLEASE READ:
When working on or around a vehicle, the following
general precautions should be observed:
1. Park the vehicle on a level surface, apply the
parking brakes, and always block the wheels.
2. Stop the engine when working around the vehicle.
3. If the vehicle is equipped with air brakes, make
certain to drain the air pressure from all reservoirs
before beginning ANY work on the vehicle.
4. Following the vehicle manufacturers
recommended procedures, deactivate the electrical
system in a manner that removes all electrical
power from the vehicle.
5. When working in the engine compartment the
engine should be shut off. Where circumstances
require that the engine be in operation, EXTREME
CAUTION should be used to prevent personal injury
resulting from contact with moving, rotating,
leaking, heated, or electrically charged
components.
6. Never connect or disconnect a hose or line
containing pressure; it may whip. Never remove a
component or plug unless you are certain all
system pressure has been depleted.
7. Never exceed recommended pressures and always
wear safety glasses.
8. Do not attempt to install, remove, disassemble or
assemble a component until you have read and
thoroughly understand the recommended
procedures. Use only the proper tools and observe
all precautions pertaining to use of those tools.
9. Use only genuine Bendix replacement parts,
components, and kits. Replacement hardware,
tubing, hose, fittings, etc. should be of equivalent
size, type, and strength as original equipment and
be designed specifically for such applications and
systems.
10. Components with stripped threads or damaged
parts should be replaced rather than repaired. Re-
pairs requiring machining or welding should not
be attempted unless specifically approved and
stated by the vehicle or component manufacturer.
11. Prior to returning the vehicle to service, make
certain all components and systems are restored
to their proper operating condition.
To Next Page
Loading...
