EasyManuals Logo

PREVOST X3-45 Multiplex User Manual

PREVOST X3-45 Multiplex
1422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #641 background imageLoading...
Page #641 background image
1 Introduction
7
Meritor WABCO Maintenance Manual MM-0112 (Revised 07-05)
Figure 1.6
ABS Sensors
ABS sensor systems consist of a tooth wheel mounted on the hub of
each monitored wheel and a sensor installed so that its end is
against the tooth wheel. The sensor continuously sends wheel
speed information to the ECU. A sensor clip holds the sensor in
place at the tooth wheel.
The type of axle determines sensor mounting location.
Steering axle sensors are installed in the steering knuckle or in a
bolted-on bracket.
Drive axle sensors are mounted in a block attached to the axle
housing or in a bolted-on bracket.
Check the wheel speed sensors for correct alignment and apply
lubricant to the sensor and sensor clip whenever wheel-end
maintenance is performed. Refer to Section 3 and Section 4.
Figure 1.6
1002007e
REAR ABS
VALVE PACKAGE
WHEEL
SPEED SENSORS
FRONT ABS
VALVE PACKAGE
ECU
WHEEL
SPEED SENSORS
4S/4M CONFIGURATION — ABS ONLY
ELECTRICAL LINES
AIR LINES
xxxxx xxxxx
xxxxx xxxxx
472 500 30. 0
MADE IN GERMANY
001 20/98
LAMPS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PREVOST X3-45 Multiplex and is the answer not in the manual?

PREVOST X3-45 Multiplex Specifications

General IconGeneral
Length45 ft
Width102 in
EngineVolvo D13
Horsepower500 hp
GVWR54, 000 lbs
Height146 in
Sleeping CapacityVaries based on floor plan
Water CapacityVaries based on floor plan

Related product manuals