Section 13: WHEELS, HUBS & TIRES
PA1562
9
8. Assemble axle flange to axle using a new
gasket. Apply sealant in stud area. After both
wheels have been assembled according to
above procedure, fill the differential with the
recommended lubricant to the proper factory
recommended level.
NOTE
During regular inspection, do not forget to
check lubricant level in differential. Clean
thoroughly or replace vent as required.
10. SPARE WHEEL
Tire failure is a rare event if tires are properly
cared for. In case of a flat tire, move vehicle a
safe distance away from traffic and apply
parking brake. Remember to use the hazard
flashers and according to the Highway Code
regulations, set up the triangular reflectors (see
"Emergency Warning Reflectors" in the
Operator's Manual) at an adequate distance, to
warn incoming motorists. This kit is located at
the ceiling of the first baggage compartment, on
the R.H. side.
FIGURE 6: WARNING REFLECTORS LOCATION 23376
The spare wheel is stored in a dedicated
compartment behind the front bumper. To
access, pull the release handle located in the
front service compartment. Although the bumper
is heavy, sprung hinges permit one person
operation.
When closing bumper compartment, make sure
bumper is securely installed.
WARNING
This compartment has not been designed for
storage. Never leave loose objects in this area
since they may interfere with steering linkage
mechanism. Make sure bumper is safely
locked in place after closing the compartment.
10.1 PULLING OUT SPARE WHEEL
To remove the spare, untighten the pressure
screw holding the tire in place, then press down
on the spring loaded locking pin located at the
top of the retaining bracket and remove the
bracket. Using the strap, pull the spare out of the
compartment (refer to the following illustrations).
Rollers ease manipulation. Remove the
protective cover. Install the flat in place of the
spare by reversing the procedure. Do not forget
to have the flat repaired as soon as possible.
FIGURE 7: SPARE WHEEL COMPARTMENT 18614
FIGURE 8: SPARE WHEEL AND TIRE 18415
NOTE
The jack and wheelnut wrench are stored in
front service compartment.
The jack/tools kit stowed in the front service
compartment contains a:
1. 30 ton hydraulic jack;
2. Wheel nut wrench and lever.
FIGURE 9: FRONT SERVICE COMPARTMENT 23377