Fig. 23
mark
housing
protecting cap
steering input shaft
mark
steering drop arm
mark
mark
sector shaft
protecting cap
Removal and Re-Installation of the Steering Gear
28 Instructions on Design, Operation, Maintenance and Inspection
2.4 Place the steering gear into the mounting bracket and fasten it with screws.
N
ote:
Make sure that the position of the fitting bolt is correct.
For the tightening torque, please refer to the technical cover sheet of the spare parts list.
If no data is given in the list, the values below shall apply.
Depending on the vehicle type, space restrictions may require a previous fitment of the drop
arm.
Tightening torque:
Thread
Screw grade Tightening torque
M18x1.5 10.9 410+10% Nm
M20x1.5 10.9 520+10% Nm
Attention:
Conform to vehicle manufacturer’s instructions.
2.5 Fit the universal joint or the elastic coupling between the steering column and the steering
gear.
Note:
The clamping slot in the universal joint must point towards the mark on the cover cap or on
the input shaft.
To Next Page
Loading...