PREVOST X3-45 Multiplex User Manual

Initial PS Installation
1. Install fittings to input and output ports, if fittings for
this application can be preinstalled.
2. Install a gear on the input shaft, if required for this
application.
3. Install the retaining nut, if required for this applica-
tion, and torque to the manufacturer's specification.
4. Position either a gasket or o-ring, dependent on the
application, which will seal the pump face to the
mounting surface.
5. Engage the input shaft.
6. Tighten the mounting bolts to manufacturer's
specifications.
7. Connect the input and output lines.
8. Fill the reservoir.
9. Start the vehicle to purge the system.
10. Turn off the vehicle andcheck the fluid level in the
reservoir. Add fluid as necessary.
11. Bleed the system if necessary using instructions on
page 36.

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan