Stop the vehicle with wheels pointed straight ahead.
Clean off all outside dirt from around fittings and hose connections before you remove the pump.
Remove the pump from the vehicle and take it to a clean work surface.
Clean and dry the pump before you start to disassemble it.
As you disassemble the pump, clean all parts in clean, OSHA approved solvent, and air blow-dry them
only.
Because they are flammable, be extremely careful when using any solvents. Even a small
explosion or fire could cause injury or death.
Wear eye protection and be sure to comply with OSHA or other maximum air pressure
requirements.
Never steam clean or high-pressure wash hydraulic steering components. Do not force or
abuse closely fitted parts. Use care that bearing and sealing surfaces are not damaged by
the assembly and disassembly procedures.
Keep each part separate to avoid nicks and burrs.
Disassembly Preparation
! WARNING
!
WARNING
CAUTION
!
To Next Page
Loading...