Rohde & Schwarz ESW Series - Page 598

Remote Commands in the Receiver Application
R&S
®
ESW
598User Manual 1177.6298.02 ─ 08
GDI
Graphics Device Interface
Default format for output to a printer configured under Windows.
Must be selected for output to the printer interface.
Can be used for output to a file. The printer driver configured
under Windows is used to generate a printer-specific file format.
DOC | PDF
File type for test reports
Available when HCOPy:MODE = REPort.
BMP | JPG | PNG | PDF | SVG
Data format for output to files
Example:
HCOP:DEV:LANG1 PNG
Manual operation: See "Destination" on page 284
See "General properties of the test report document"
on page 294
HCOPy[:IMMediate<1|2>]
This command initiates a print job.
If you are printing to a file, the file name depends on MMEMory:NAME.
The command also generates a measurement report when you have selected
HCOPy:MODE REPort. Note that you have to add at least one dataset to the report
with HCOPy:TREPort:NEW on page 614 or HCOPy:TREPort:APPend. Otherwise
creating the report results in an error.
Suffix:
<1|2>
.
Printing device.
Example:
HCOP:MODE REPort
MMEM:NAME 'C:\WooHoo.pdf'
HCOP:DEV:LANG PDF
HCOP:TREP:NEW
HCOP
Creates a measurement report (in pdf format).
Manual operation: See "Print" on page 283
See "Configuration and printout of the test report" on page 298
HCOPy[:IMMediate<1|2>]:NEXT
This command initiates a print job.
If you are printing to a file, the file name depends on MMEMory:NAME. This command
adds a consecutive number to the file name.
Suffix:
<1|2>
.
Printing device.
Manual operation: See "Print" on page 283
Data Management