Rohde & Schwarz ESW Series - Page 606

Remote Commands in the Receiver Application
R&S
®
ESW
606User Manual 1177.6298.02 ─ 08
HCOPy:TREPort:ITEM:TEMPlate:DELete........................................................................ 613
HCOPy:TREPort:ITEM:TEMPlate:LOAD.......................................................................... 613
HCOPy:TREPort:ITEM:TEMPlate:SAVE...........................................................................613
HCOPy:TREPort:NEW................................................................................................... 614
HCOPy:TREPort:PAGesize.............................................................................................614
HCOPy:TREPort:PAGecount:STATe.................................................................................614
HCOPy:TREPort:PCOLors[:STATe]..................................................................................615
HCOPy:TREPort:TDSTamp[:STATe].................................................................................615
HCOPy:TREPort:TEST:REMove......................................................................................615
HCOPy:TREPort:TEST:REMove:ALL............................................................................... 616
HCOPy:TREPort:TITLe...................................................................................................616
HCOPy:TREPort:TITLe:STATe........................................................................................ 616
HCOPy:MODE <Mode>
Selects the output of the HCOPy[:IMMediate<1|2>] command.
Parameters:
<Mode> SCReen
HCOPy:IMMediate prints the current screen contents.
REPort
HCOPy:IMMediate generates a measurement report.
*RST: SCReen
Example:
HCOP:MODE REPort
HCOP
Creates a file containing the measurement report.
Manual operation: See "Configuration and printout of the test report" on page 298
HCOPy:TREPort:APPend
This command adds the current measurement results to the test report.
The saved data depends on the items you have selected with HCOPy:TREPort:
ITEM:SELect on page 610.
Example:
Perform a measurement, then:
HCOP:TREP:NEW
Creates a new test report with the results of the first measure-
ment.
Perform another measurement, then:
HCOP:TREP:APP
Adds the results of the second measurement to the test report.
Usage: Event
Manual operation: See "Adding and removing datasets" on page 299
HCOPy:TREPort:DESCription <Description>
This command defines the description of the test report as shown on its title page.
Data Management