Rohde & Schwarz SMAB-B92 - Page 144

Avionic Standards
R&S
®
SMA100B
142User Manual 1178.3834.02 ─ 05
This dialog comprises COM/ID settings related to the ILS localizer component of
the ILS signal.
Settings
COM/ID State..............................................................................................................142
Code............................................................................................................................142
Frequency................................................................................................................... 142
Period..........................................................................................................................142
Depth...........................................................................................................................142
Time Schema.............................................................................................................. 143
Dot Length...................................................................................................................143
Dash Length ...............................................................................................................143
Symbol Space ............................................................................................................143
Letter Space ...............................................................................................................143
COM/ID State
Enables/disables the COM/ID signal.
See also Chapter D, "Morse Code Settings", on page 740.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid[:STATe] on page 562
Code
Sets the coding of the COM/ID signal by the international short name of the airport
(e.g. MUC for the Munich airport).
The COM/ID tone is sent according to the selected code, see Chapter D, "Morse Code
Settings", on page 740.
If no coding is set, the COM/ID tone is sent uncoded (key down).
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:CODE on page 560
Frequency
Sets the frequency of the COM/ID signal.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:FREQuency on page 561
Period
Sets the period of the COM/ID signal.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:PERiod on page 561
Depth
Sets the AM modulation depth of the COM/ID signal.
Note: The sum of Sum of Depth and COM/ID > Depth must be smaller than 100 %.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:DEPTh on page 560
ILS Configuration and Settings