Rohde & Schwarz SMAB-B92 - Page 246

Improving Level Performance
R&S
®
SMA100B
244User Manual 1178.3834.02 ─ 05
Distal - Pulse Data Analysis
Sets the upper reference level in terms of percentage of the overall pulse level (power
or voltage related). The distal power defines the end of the rising edge and the start of
the falling edge of the pulse.
Remote command:
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:PULSe:THReshold:POWer:
HREFerence on page 462
:TRACe<ch>[:POWer]:SWEep:PULSe:THReshold:POWer:HREFerence
on page 494
Mesial - Pulse Data Analysis
Sets the medial reference level in terms of percentage of the overall pulse level (power
or voltage related). This level is used to define the pulse width (τ) and pulse period.
Remote command:
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:PULSe:THReshold:POWer:
REFerence on page 462
:TRACe<ch>[:POWer]:SWEep:PULSe:THReshold:POWer:REFerence
on page 495
Proximal - Pulse Data Analysis
Sets the lower reference level in terms of percentage of the overall pulse level (power
or voltage related).
The proximal power defines the start of the rising edge and the end of the falling edge
of the pulse.
Remote command:
:SENSe<ch>[:POWer]:SWEep:TIME[:SENSor]:PULSe:THReshold:POWer:
LREFerence on page 462
:TRACe<ch>[:POWer]:SWEep:PULSe:THReshold:POWer:LREFerence
on page 495
Configure Pulse Data Notifications
Access:
1. Select "Clk Syn/Power Sens" > "NRP Power Analysis".
2. In the diagram window, open the context-sensitive menu.
3. Select "Trace/Pulse Data Notifications/ Trigger".
4. Select the "Pulse Data Notifications" tab.
Using Power Sensors