Rohde & Schwarz SMAB-B92 - Page 599

Remote Control Commands
R&S
®
SMA100B
597User Manual 1178.3834.02 ─ 05
[:SOURce<hw>]:FREQuency:PLL:MODE <Mode>
Selects the PLL (Phase Locked Loop) bandwidth of the main synthesizer.
Parameters:
<Mode> NORMal | NARRow
NORMal
Maximum modulation bandwidth and FM/PhiM deviation.
NARRow
Narrow PLL bandwidth
*RST: NORMal
Example:
SOURce:FREQuency:PLL:MODE NORMal
Manual operation: See "Main PLL Bandwidth" on page 65
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:HIGH?
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:LOW?
Queries the minimum frequency of the frequency range for phase continuous settings.
The minimum frequency of the frequency range depends on the mode selected with
the command [:SOURce<hw>]:FREQuency:PHASe:CONTinuous:MODE.
Return values:
<Low> float
Range: 1E5 to 6E9
Increment: 0.01
*RST: 1E9
Default unit: Hz
Example:
SOURce:FREQuency:PHASe:CONTinuous:MODE NARR
SOURce:FREQuency:PHASe:CONTinuous:STATe 1
SOURce:FREQuency:PHASe:CONTinuous:LOW?
998 720 930.20
Usage: Query only
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:MODE <Mode>
Selects the mode that determines the frequency range for the phase continuity.
To query the frequency range, use the commands [:SOURce<hw>]:FREQuency:
PHASe:CONTinuous:HIGH? and [:SOURce<hw>]:FREQuency:PHASe:
CONTinuous:LOW?
Parameters:
<Mode> NARRow | WIDE
NARRow
Small frequency range, asymmetrically around the RF fre-
quency.
SOURce Subsystem