Samsung WEC8050 - Managing AP File Transmission; APC Redundancy Configuration

WEC8500/WEC8050 (APC) Operation Manual v10.1 132
©Samsung Electronics America
Managing AP File Transmission
It provides the configuration and transmission management function for the tech support
file of the AP.
Tech Support Information File
1 Go to configure  APC mode of CLI.
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc#
2 Configure a file transmission method to collect the AP Tech support
information.
o tech-support [MODE]
Parameter
Description
MODE
Selects file transmission method (ftp/sftp/http).
• tftp is not supported.
3 If AP debug information collection is failed, configure maximum number
of retries.
o tech-support max-retry [COUNT]
Parameter
Description
COUNT
Number of retries.
4 To check the configuration information, use the ‘show ap tech-support’
command.
APC Redundancy Configuration
An operator can add a backup APC to an AP to make the backup APC provide the service
even when an APC fault occurs.
The maximum number of backup APCs that can be registered to one AP per model is as
follows:
APC Model
The maximum number of APC systems that can be
registered
WEC8500
3 (Primary Server, Secondary Server, Tertiary Server)
WEC8050
2 (Primary Server, Secondary Server)
If a fault occurs to the primary APC while an AP is connected to the primary APC, the AP
is connected to the secondary APC. If a fault also occurs to the secondary APC, the AP is
connected to the tertiary APC. For reference, the WEC8050 model does not support a
tertiary APC.
Operator can also configure fallback to return to the original APC from the backup APC