Samsung WEC8050 - SNMP Community Configuration; CLI Basic Usage

WEC8500/WEC8050 (APC) Operation Manual v10.1 21
©Samsung Electronics America
In case of WEC8050, there is no management (mgmt0) port. After
establishing an IP address in one of ports ge1 to ge4 by referring to the
contents of ‘Port Configuration’ and then using the CLI, connect the Ethernet
cable to the port.
SNMP Community Configuration
To connect to the web server of APC, it is necessary to add Simple Network Management
Protocol (SNMP) community through CLI. For more information, see ‘SNMP Configuration’
part in ‘System Management’ Chapter.
CLI Basic Usage
The CLI is a text command based interface used to change or retrieve the system
settings. Several users can change the settings at the same time using the CLI of the same
system. Because privilege per user is already configured, a user can execute a command
allowed by the user’s privilege. Various commands are available for each system function.
For more information, see ANNEX ‘CLI Command Structure’.
Command Help
The CLI provides a help for all the commands. To see a help for a command and
parameter, enter ‘?’. Based on an input character, it shows a help for a command or
parameter that can be entered.
Category
Description
?
Displays the command list and help at the current level
Command ?
Displays the parameter and help required for a command
A usage example is given below.
WEC8500# show ?
80211a Display 802.11a network settings
80211bg Display 802.11bg network settings
80211h Display 802.11h configuration
access-list List IP access lists
alarm Show alarm information
ap Show ap information
ap-debug Show ap debug information
...
vap Show vap information
version Show package version information
vlan Display VLAN information
vqm Show vqm command
vrrp VRRP information
wids Wids command
wips Wips command
wireless-acl-list Show wireless-acl-list
wlan Show wlan information
WEC8500#