Samsung WEC8050 - Upgrade

WEC8500/WEC8050 (APC) Operation Manual v10.1 470
©Samsung Electronics America
Upgrade
The APC provides the upgrade function and version checking function that applies a new
version of package when it is distributed.
Checking Package Version
You can check the version of a current system by using the following command.
• show version
The following shows the execution results of the command:
WEC8500# show version
Samsung package version information
Primary (currently running)
ver : 1.4.4.R
buildTime : Fri Sep 6 06:08:35 2013
builder : apcbuild
buildDir : /home2/apcbuild/release/wec8500_1.4.4
Backup
ver : 1.4.4.R
buildTime : Fri Sep 6 06:08:35 2013
builder : apcbuild
buildDir : /home2/apcbuild/release/wec8500_1.4.4
Boot rom version information
ver : GC15
System Upgrade
The APC does system upgrade using CLI and Web UI.
Configuration using CLI
Apply a new package to the system by using the following command.
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2 Perform upgrade by using a package.
o package upgrade [FILE_NAME]
Parameter
Description
FILE_NAME
Package file to upgrade
The package must be located in the /user/package directory.
A usage example is provided below. When the upgrade is completed,
the system is rebooted to apply the package.
When executing the package upgrade command, the message
recommending saving the configuration file is displayed.
If you save the current configuration, operator can use it for any future