Samsung WEC8050 - Station-Based;Airtime-Based Adaptive Load Balancing

WEC8500/WEC8050 (APC) Operation Manual v10.1 340
©Samsung Electronics America
Station-based/AirTime-based Adaptive Load
Balancing
Station-based Adaptive Load Balancing performs load balancing based on the number of
stations and RSSI in an individual radio unit of the AP group.
AirTime-based Adaptive Load Balancing performs load balancing based on the channel
utilization per station and interference in an individual radio unit of the AP group.
Configuring Basic Function and Setting Load Balancing Parameters of AP Group are
available and the settings of the load balancing parameters in individual APs are available
to apply a different value set only for a specific AP.
Basic Setting of Load Balancing
Station-based/AirTime-based Adaptive Load Balancing operates only when it is enabled
in the setting of the basic functions and configures options applied to the overall function
operation.
Configuration using CLI
To configure the basic function, execute the commands as follows:
1 Go to the configure  load-balancing configuration mode of CLI.
APC# configure terminal
APC/configure# load-balancing
APC/configure/load-balancing#
2 Activate the Load Balancing function.
o enable
3 If a function of distributing stations uniformly among APs is necessary,
activate the Active Load Balancing function. This is not applied to
AirTime-based Load Balancing. (Default: no active).
o active
4 To activate the Active Load Balancing function, set up the interval for
attempting to distribute uniformly.
o interval [NUMBER]
Parameter
Description
NUMBER
Interval for performing active load balancing (sec)
5 To allow load balancing among APs which use the same channel, set
the following option (Default: no allow-channel):
o allow-channel
6 To calibrate the RSSI value depending on types of stations, the
calibration value must be set.
o calibration mobile [NUMBER]