WEC8500/WEC8050 (APC) Operation Manual v10.1 61
©Samsung Electronics America
Static Route window. If the added information is not displayed, it means the added routing
information is not enabled. If the operational status of an interface that will be used as a
routing result is not UP, check the interface status through CLI or Web UI.
Because only enabled routing entries are listed in the Web UI, you cannot remove a
disabled routing entry.
IP Multicast Routing Configuration
3 Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
1 Enable or disable multicast-routing.
o ip multicast-routing
o no multicast-routing
2 Check multicast-routing using the ‘show running-config network’
command.
PIM Configuration
The procedure for Protocol Independent Multicast (PIM) configuration is given below:
1 Go to configure interface configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# interface ge2
2 Configure the PIM sparse mode to an interface.
WEC8500/configure/interface ge2# ip pim sparse-mode
3 Check a configured PIM using the ‘show running-config network’
command.
To check the multicast-routing table, use the ‘show ip mroute’ command.
WEC8500# show ip mroute
(90.90.1.242, 224.0.1.1) Iif: mgmt0 Oifs: pimreg
OSPF Configuration
General Settings
Configuration using CLI
1 Go to configure ospf configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# router ospf
To Next Page
