WEC8500/WEC8050 (APC) Operation Manual v10.1 424
©Samsung Electronics America
Chapter 9 IP Application
In this chapter, the IP application functions available in the APC and each configuration
method are described.
DNS
The DNS is a network service that interprets a domain or host name into an IP address.
The APC gets DNS information from a DNS server and provides the DNS relay function
that relays the DNS server and a client. If a wireless terminal connected to the APC
configures the APC as a DNS server, it can receive the DNS service.
If a DNS server is connected to the APC and a DNS proxy is configured, a station
connected to the APC can receive the DNS service by configuring the APC as a DNS
server.
DNS Client Configuration
Configuration using CLI
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
2 Configure a DNS client.
o ip dns client enable: Enable
o no ip dns client enable: Disable
3 Configure a DNS server to which DNS will be requested. You can enter
maximum 3 DNS server each that is IPv4 and IPv6 addresses.
o ip dns name-server [A.B.C.D/A:B:C::D]: Configures a DNS server.
o no ip dns name-server [A.B.C.D/A:B:C::D]: Deletes a configured DNS
server.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<DNS> menu in the sub-menus.
To Next Page
Loading...
