WEC8500/WEC8050 (APC) Operation Manual v10.1 476
©Samsung Electronics America
Configuration Synchronization
For all APCs in an environment configured with multiple APCs to provide the same WLAN
service, all their service-related settings, other than the individual network settings, must
be identical. For this, the system provides a function for automatically synchronizing
service-related configurations across multiple APCs.
When service settings are changed on the master APC, the settings are automatically
applied to the connected slave devices. Service configuration synchronization currently
supports two APCs only.
Configuration Information Synchronization
Configuration using CLI
[Adding APC to APC List]
Add APCs to synchronize to the APC list by referring to ‘APC List Management’.
[Adding APC to Sync List]
After adding APCs to the APC list, APCs to synchronize must be added to the Sync List.
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure# configuration-sync
WEC8500/configure/configuration-sync#
2 Add APCs to the Sync List.
o add-apc[INDEX][APC_NAME][IP_VERSION][IP_ADDRESS]
[Deleting APC from Sync List]
Registered APCs can be deleted from the Sync List.
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure# configuration-sync
WEC8500/configure/configuration-sync#
2 Delete APCs from the Sync List. To delete all APCs from the Sync List,
enter the ‘del-apc-all’ command.
o del-apc [INDEX]
o del-apc-all
To Next Page
