Samsung WEC8050 - Managing Real-Time Information Collection

WEC8500/WEC8050 (APC) Operation Manual v10.1 462
©Samsung Electronics America
2 ‘Disable’ the traffic performance information management.
WEC8500/configure# no stats-report enable
3 To check the configured information, use the ‘show stats-report conf’
command.
Managing Real-time Information Collection
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2 To collect real-time information, execute the following command. At this
time, you must specify the name and status of an interface whose
information will be collected.
o stats-report current-stats [INTERFACE_NAME] [STATE]
Parameter
Description
INTERFACE_NAME
Name of an interface to collect or stop collection
STATE
Status of real-time information (start/stop)
• start: Starts real-time information collection
• stop: Stops or initializes the real-time information
collection.
3 To check the entered information, use the ‘show stats-report conf’
command.
4 To check the information of a configured interface when the real-time
information collection is configured, execute the following command:
o show stats-report current-stats [INTERFACE_NAME]
If the real-time information collection is suspended or initialized, you
cannot check the real-time information of the interface.
WEC8500/configure# show stats-report current-stats ge3
Error: This interface was not configured to gather statistics.