WEC8500/WEC8050 (APC) Operation Manual v10.1 440
©Samsung Electronics America
System Management
Retrieving System Information
Retrieving with CLI
By using the ‘show system info’ command, you can check the system configuration
information of the APC system such as version information, memory information, disk
information, temperature sensor, fan status and so on.
The execution results of the command in WEC8500 are as follows:
WEC8500/configure# show system info
-----------------------------------------------------
Item System Info
-----------------------------------------------------
System Info :
model type WEC8500
system description Samsung AP Controller
board version 0.1
cpld version 0.5
system mac address 00:7e:37:00:1e:70
system total memory 16046580 KBytes
system total disk 13520032 KBytes
Temperature Sensor Status :
cpu upside sensor OK
cpu downside sensor OK
board sensor OK
Fan Status :
fan[0] OK
fan[1] OK
fan[2] OK
fan[3] OK
Power Supply Status :
Power Supply[0] Equipped
Status OK
Power Supply[1] Not Equipped
Status -
-----------------------------------------------------
The execution results of the command in WEC8050 are as follows:
WEC8050# show system info
-----------------------------------------------------
Item System Info
-----------------------------------------------------
System Info :
model type WEC8050
system description Samsung AP Controller
board version 0.0
cpld version 0.1
serial number
system mac address 00:7e:37:00:21:d4
system total memory 4855272 KBytes
system total disk 12191593 KBytes
Temperature Sensor Status :
CPU sensor1 OK
CPU sensor2 OK
Fan Status :
To Next Page
