Samsung WEC8050 - Spanning Tree

WEC8500/WEC8050 (APC) Operation Manual v10.1 56
©Samsung Electronics America
[switchport]
This command configures a switch port that is the layer 2 protocol characteristic
information of the current VLAN. The ‘no’ parameter is used for default configuration. Go
to interface mode and then execute the command.
• switchport
• no switchport
Spanning Tree
Configuration using CLI
To set up spanning tree related functions, go to configure mode by executing the following
command:
WEC8500# configure terminal
The related command is as follows:
[bridge forward-time]
This command configures the forward time of a bridge. The ‘no’ parameter is used for
default configuration.
• bridge 1 forward-time [FORWARD_DELAY]
• no bridge 1 forward-time
Parameter
Description
FORWARD_DELAY
Forward time delay (range: 4-30 s, default: 15)
[bridge hello-time]
This command configures the hello time of a bridge. The time required when a bridged
LAN is changed to Bridge Protocol Data Units (BPDUs) is called as hello-time. The ‘no’
parameter is used for default configuration.
• bridge 1 hello-time [HELLOTIME]
• no bridge 1 hello-time
Parameter
Description
HELLOTIME
Hello BPDU interval (range: 1-10 s)
[bridge instance priority]
This command configures the bridge priority of MST instance. The ‘no’ parameter is used
to delete priority.
• bridge 1 instance [INSTANCE_ID] priority [BRIDGE_PRIORITY]
• no bridge 1 instance [INSTANCE_ID]