Samsung WEC8050 - Page 76

WEC8500/WEC8050 (APC) Operation Manual v10.1 57
©Samsung Electronics America
Parameter
Description
INSTANCE_ID
Instance ID (range: 1-64)
BRIDGE_PRIORITY
Bridge priority (range: 0-61440)
[bridge max-age]
This command configures the max-age of a bridge. The ‘no’ parameter is used for default
configuration.
• bridge 1 max-age [MAXAGE]
• no bridge 1 max-age
Parameter
Description
MAXAGE
Configures a maximum time (range: 6-40 s)
[bridge max-hops]
This command configures the maximum allowed number of hops of a Bridge Protocol
Data Unit (BPDU) bridge in the MST area.
The ‘no’ parameter is used for default configuration.
• bridge 1 max-hops [HOP_COUNT]
• no bridge 1 max-hops
Parameter
Description
HOP_COUNT
Maximum allowed number of hops
[bridge multiple-spanning-tree enable]
This command configures a MSTP bridge. The ‘no’ parameter is used to clear the
configuration.
• bridge 1 multiple-spanning-tree enable
• no bridge 1 multiple-spanning-tree enable
[bridge rapid-spanning-tree enable]
This command configures a RSTP bridge. The ‘no’ parameter is used to clear the
configuration.
• bridge 1 rapid-spanning-tree enable
• no bridge 1 rapid-spanning-tree enable(bridge-forward)
[bridge spanning-tree enable]
This command configures a STP bridge. The ‘no’ parameter is used to clear the
configuration.
• bridge 1 spanning-tree enable
• no bridge 1 spanning-tree enable(bridge-forward)
[bridge priority]
This command configures the priority of a bridge. The ‘no’ parameter is used to delete a