Samsung WEC8050 - Limiting the Number of Connected Users

WEC8500/WEC8050 (APC) Operation Manual v10.1 315
©Samsung Electronics America
Limiting the Number of Connected Users
The W-EP wireless LAN system limits the number of wireless terminals connected to each
AP.
The limitation is per radio (2.4/5 GHz bandwidth) or WLAN for each AP.
Limiting Connections per Radio
Configuration using CLI
1 Go to the configure mode of the CLI.
APC# configure terminal
APC/configure#
2 Configure connection limitation.
o [RADIO] max-associated-stations [MAX_STATION] global:
Configures connection limitation per wireless bandwidth. When you
enter the ‘global’ parameter at the end, connection limitation is
applied to all the APs.
o [RADIO] max-associated-stations [MAX_STATION] [TARGET]
[AP_ID]: Configures connection limitation to a specific AP.
o [RADIO] max-associated-stations [MAX_STATION] [group] [AP
group ID]: Configures connection limitation to a specific AP group.
Parameter
Description
RADIO
Wireless area to configure
[80211bg/80211a]
• 80211bg: 2.4 GHz area
• 80211a: 5 GHz area
MAX-STATION
Maximum number of wireless terminals that can be
connected (default: 127)
TARGET
Configuration range
• AP: Index of an AP to configure
• Global: All APs connected to an APC
AP_ID
AP ID (range: 1-3000)
AP group ID
AP group ID (range: 1-3000)
3 To check the configuration information, use the ‘show [80211a |
80211bg] radio-config [ap <ID> | group <ID> | global]’ command.
Configuration using Web UI
[Configures per Radio]
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Radio>  <802.11a/n> or <802.11b/g/n>  <General> menu in the sub-menus.