Samsung WEC8050 - Figure 197. Configuring 802.11 H; H Configuration

WEC8500/WEC8050 (APC) Operation Manual v10.1 275
©Samsung Electronics America
802.11h Configuration
The APC supports the configuration and transmission power limitation for the Dynamic
Frequency Selection (DFS) function in an AP. When the AP detects radar, an event is sent
to the WEM and a detouring channel can be configured in the AP.
Configuration using CLI
For channel switching announcement related configuration and power constraint value
configuration in an AP, execute the command as follows:
1 Go to configure  80211h configuration mode of CLI.
APC# configure terminal
APC/configure# 80211h
APC/configure/80211h#
2 Configure the 802.11h information.
o channel-switch [MODE] [RESTRICTION] [SWITCH COUNT]
Parameter
Description
MODE
Whether the switching announcement function is
enabled/disabled
RESTRICTION
Whether the channel packet transmission restriction mode is
enabled (disable/enable)
SWITCH COUNT
Waiting time until channel switching announcement
3 Configure the transmission power of a wireless terminal.
o power-constraint [VALUE]
Parameter
Description
VALUE
Transmission power (0-31 dB)
4 To check the configuration information, use the ‘show 80211h
configuration’ command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <CONFIGURATION> and then select
the <RADIO>  <802.11a/n>  <802.11h> menu in the sub-menus.
Figure 197. Configuring 802.11h
• POWER CONSTRAINT: Power constraint value (0-100)
• CHANNEL SWITCH: Enables channel switch announcement.